Camouflage Carpentry Sets w/ Hammer Sleeve
Want some camo in your life? These special edition Badgers are made with US Military camouflage fabrics and include a sewn-in hammer sleeve. We’re currently able to offer these limited sets in MARPAT (Marine pattern) and Scorpion pattern. The MARPAT is a slightly smaller denier (size of thread in weave) at 720D versus our standard 1000D. But we warrantee it just the same, as we feel it will perform better than some commercial 1000D fabric. The interior of both styles is made of our standard 1000D military-grade USA-made fabric.
Designed with carpenters in mind, but offering enough storage solutions for several trades, this mid-sized tool belt is well suited for both interior and exterior work. It's small enough to maneuver while doing interior work yet large enough to hold plenty of tools and fasteners for jobs that require more storage. This was Badger's first full set and was the starting point for all of our other sets. It's an ideal daily workhorse for many of our customers. This set up consists of the contoured belt with metal COBRA® buckle, C1 on the dominant side and the C2 on the non-dominant. C1 Bag Configuration: Tape pouch, 5 tool slots in main pouch-three along inside back and two inside front, single outside lower pouch with tool slot, rear tool loop. Pencil/utility combo up front with three small slots and one deep pocket. Overall length is approximately 14". C2 Bag Configuration: Tape pouch with 4 interior 1" wide elastic slots, speed square slot in main pouch with wide tool slot below, lower fastener pouch with slot, two front tool pockets, 2 stacked rear tool slots and a reinforced bar sleeve on the underside of the bag. Overall length is approximately 14". As with all Badger bags, the bottom of the main and fastener pouches are reinforced with USA made tactical webbing to increase puncture and abrasion resistance. We strongly recommend getting a hammer sleeve with this rig. It’s a natural fit. Before choosing belt size PLEASE read our belt sizing guide. Do NOT just go by your pants size as it can lead to an incorrectly fitted belt.